Lancer L4-135 2.2L SOHC (1986)
reinforcement bracket. Next, weld over top of both rivets (Figure 3).
Welding Notes & Torque Requirements
WELDING NOTES
^
ARC or MIG (CO2) Weld Only
Gas or TIG (HELI-ARC) Welding is not permissible.
A.W.S.
E-6011
ARC Welding Rod - 1/8" Diameter
(preferred)
E-6012
Acceptable
E-6013
Acceptable
A.W.S.
E-70S6
MIG Welding Wire - .035" (preferred)
E-70S3
Acceptable
^
Repair to be made by a qualified welder to ensure good weld quality. If your facility is not equipped or staffed to handle the weld repair, sublet
that portion to a qualified welding facility.
^
Do not quench (water cool) after welding -- all to air cool.
4.
After repaired area has cooled, spray with Mopar Belt Dressing, PN 4318069, to protect against metal surface corrosion.
5.
Reassemble the adjuster to the seat assembly and reinstall the completed assembly into the vehicle.
NOTE:
VEHICLES WITH 50/50 SEAT - SECURE THE IN-BOARD SEAT BELT TO THE FLOOR AND RECONNECT THE
WIRING PIGTAIL.
