Lancer L4-135 2.2L SOHC (1986)
Crankshaft Position Sensor: Service and Repair
Disassembly & Assembly
Fig. 6 Typical Hall Effect electronic ignition distributor
DISASSEMBLY
2.2 & 1.7 Liter Engine
1.
Remove rotor from shaft and disconnect pickup electrical connector on all except 1986-87 models.
2.
On all 1984-85 models, remove Hall Effect pickup retaining clips. On 1986-87 models, pickup is held in place by cap retaining screws.
3.
On all models, remove Hall Effect pickup assembly.
4.
Remove distributor drive gear roll pin using punch, then remove drive gear, Fig. 6.
5.
Remove drive gear thrust washer and distributor shaft.
6.
Remove distributor to block seal.
