Lancer L4-135 2.2L SOHC (1986)
a.
Remove the convolute tubing from the carburetor wiring harness and set aside.
b.
Remove the red and violet wire from the 6-way electrical plug.
c.
Remove the wiring harness stand-off clamp located on the top of the carburetor.
d.
Remove the red and violet wire from the clamp.
e.
Disconnect the vacuum line attached to the solenoid kicker.
f.
Remove the solenoid kicker from the carburetor by removing the two attaching screws and set it aside.
9.
Install the new solenoid kicker (with .070" stroke), PN 4342798, onto the carburetor using the same screws.
h.
Attach the vacuum line to the new kicker.
i.
Place the red and violet wires from the solenoid kicker into the stand-off clamp and secure the clamp to the carburetor.
FIGURE 2
j.
Install the spade end of the solenoid kicker wires into the 6-way connector by simply pushing them into the cavities until they snap into place. Be
certain to place the proper wire into its proper cavity (Figure 2).
NOTE:
IF EXISTING SOLENOID HAD ONLY ONE RED WIRE, TIE WRAP SECOND RED WIRE OF NEW SOLENOID
ASSEMBLY BACK TO CONVOLUTE.
FIGURE 3
k.
Reinstall the convolute tubing around the wiring harness.
l.
Reinstall the carburetor on the intake manifold using the new flange gasket provided. Replace the choke pull-off delay valve with the new one
provided, PN 4300274 (Figure 3).
m.
Proceed to the installation of the thermal bowl vent valve.
3.
INSTALLATION OF THERMAL BOWL VENT VALVE
a.
Remove the bowl vent hose from the carburetor.
b.
Cut the rubber bowl vent hose 1-1/2" from the carburetor end.
