dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

PCM - Rough (Too Slow) Idle After Initial Cold Start|Page 65 > < Electronic Spark Advance Computer|Page 56
Page 1
background image

Powertrain Control Module: Customer Interest
PCM - Rough (Too Slow) Idle After Initial Cold Start

Models

1986 Vehicles Equipped With 2.2L EFI Engines, Manual Transmission, Federal Emission Package

Subject

Rough (Too Slow) Idle After Initial Cold Start

Index

DRIVEABILITY

Date

June 16, 1986

No.

18-27-86 REVISION A
This bulletin supersedes #18-27-86, which contained a printing error, and should be removed from your files.

SYMPTOM/CONDITION

Rough (too slow) idle after decel may be experienced in the first two (2) minutes of operation after initial cold start in ambient temperatures above 65~F.
A low mileage (green) engine may make this condition more severe.

DIAGNOSIS

Be sure all systems are operating as designed, using the 1986 2.2 EFI Driveability Test Procedures. If no problems are found, install the appropriate 
logic module listed below.

PARTS REQUTRED

1 All "K" Bodies With A/C

PN 5227764

All "G" & "H" Bodies All L.E. Series K-Wagons All S E. Series K-Wagons With A/C

1 All "K" Bodies Without A/C

PN 5227767

(except K-Wagons noted above)

1 Authorized Modification Label

PN 4275086

REPAIR PROCEDURE

This repair changes the original logic module to a revised logic module.

1.

Install appropriate logic module according to body and vehicle equipment as listed above.

PCM - Rough (Too Slow) Idle After Initial Cold Start|Page 65 > < Electronic Spark Advance Computer|Page 56