Lancer Shelby L4-135 2.2L SOHC Turbo (1989)
parts contain asbestos fibers, which, if inhaled, can cause serious injury. To clean brake parts, use a water soaked rag or a suitable vacuum cleaner
to minimize airborne dust.
Installation
1.
Lightly lubricate anchor plate shoe contact surfaces with suitable brake lube.
2.
Remove brake drum hub grease seal and bearings, then clean and repack bearings and reinstall. Install new grease seal.
3.
Assemble automatic adjuster screw assembly, return spring and shoe-to-shoe spring to brake shoe assembly.
4.
Position lining assembly near anchor plate, then assemble parking brake lever to trailing shoe webbing. Secure with C-clip.
5.
Install lining assembly onto anchor plate. When positioned, back off adjuster nut to seat brake shoe ends in wheel cylinder.
6.
Install hold-down springs.
7.
Position adjuster lever, then using suitable pliers, install adjuster lever spring.
8.
Install brake drum and bearings. Refer to individual car chapter for wheel bearing adjustment procedure.
9.
Adjust brakes. Refer to individual car chapter for procedure.
10.
Install tire and wheel assembly.
11.
If any hydraulic connections have been opened, bleed brake system.
12.
Check master cylinder level, and replenish as necessary.
13.
Check brake pedal for proper feel and return.
14.
Lower vehicle and road test. Do not severely apply brakes immediately after installation of new brake linings or permanent damage may
occur to linings and/or brake drums may become scored. Brakes must be used moderately during first several hundred miles of operation
to ensure proper burnishing.
