Magnum V6-2.7L VIN R (2005)
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Highlight the calibration shown on the screen.
f.
Select "Update Controller".
g.
Follow the on-screen instructions and perform prompts as required.
h.
When update is completed, select "OK".
7.
Check all modules for Diagnostic Trouble Codes (DTC's).
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, FCM, CCN, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the "Home" screen, record the
DTC's, and erase these DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other
modules have had their DTC's erased.
8.
Continue with Section "B"- Install the Authorized Modifications Label.
Method II. Pro2ram the PCM Usin2 StarSCAN Update CD:
NOTE:
The software update CD being used must be at level 4.07 or higher.
1.
Use the following procedure to determine the PCM part number:
a.
Connect the StarSCAN to the vehicle data link connector located under the steering column.
b.
Power ON the StarSCAN.
c.
From the StarSCAN Home Screen, select "ECU View
d.
From the StarSCAN ECU View Screen, select "PCM/NGC Engine".
e.
Record the PCM part number shown on the StarSCAN screen.
IMPORTANT:
The PCM part number recorded will be used to select the correct software. Be sure to record the part number exactly as it is shown.
f.
If the last two digits of the PCM part number are "AL" or higher, the module is up to date. No further action is required. If the last two digits
of the PCM part number are "AK" or lower continue with Step 2 of this procedure.
