Magnum V6-2.7L VIN R (2005)
Knock Sensor: Service and Repair
REMOVAL
1. Disconnect negative battery cable.
The sensors screws into the cylinder block, directly below the intake manifold.
2. Remove intake manifold.
3. Remove the passenger side cylinder head, refer to the Engine.
4. Disconnect electrical connector from knock sensor.
5. Use a crows foot socket to remove the knock sensors.
INSTALLATION
The sensors screws into the cylinder block, directly below the intake manifold.
1. Install knock sensor. Tighten knock sensor to 10 N.m (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance resulting in
possible improper spark control.
2. Attach electrical connector to knock sensor.
3. Install the passenger side cylinder head
4. Install intake manifold.
5. connect negative battery cable.
