Magnum V6-2.7L VIN R (2005)
16.
Raise the vehicle on an appropriate hoist.
17.
Remove the six (6) passenger side underbody splash shield push pins (Figure 3).
18.
Remove the underbody splash shield (Figure 3).
19.
Inspect the battery cable bulkhead stud for signs of arcing and/or cross-threading (Figure 4). If the bulkhead stud is damaged, continue with
Section B - Replace Battery Cable Bulkhead Stud.
20.
Tighten the battery cable-to-bulkhead stud fastener to 80 in-lbs (9 N.m) (Figure 4).
21.
Install the underbody splash shield (Figure 3).
22.
Install the underbody splash shield push pins (Figure 3).
23.
Lower the vehicle.
24.
Connect the negative battery cable.
25.
Install the battery access cover.
26.
Close the trunk lid.
