Magnum V6-2.7L VIN R (2005)
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
17. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive (1) with a triangular nozzle triangular nozzle approximately 6 mm (0.230 in.)
from the edge of the glass (2) starting at the bottom center of the glass.
18. Run the end of the adhesive bead (1) on the lift-gate glass (2) parallel to the start of the bead and smooth the ends flush.
19. Using an assistant, position the liftgate glass (2) over the liftgate glass opening and against the support spacers (1 and 3).
20. Using the grease pencil marks or tape as reference points, align the liftgate glass to the opening.
21. Carefully lower the liftgate glass onto the liftgate glass fence.
CAUTION: It is not possible to move the liftgate glass after installation. The liftgate glass should never be pressed into place by more
than one person, because the glass can break if pressed simultaneously on both sides.
22. Push the liftgate glass inward until the glass comes into contact with the spacers located on each side of the liftgate glass fence.
23. Connect the wire connectors to the rear window defogger terminals and, rear window mounted radio antenna, if equipped.
24. Install the liftgate trim panels.
25. Install the rear window wiper arm, if equipped.
