Magnum V6-2.7L VIN T (2007)
6. Remove the two mounting nuts (1) from the front of the instrument panel.
7. Push the ignition switch/lock assembly (3) inward toward the bulkhead.
8. Remove the SKREEM mounting screw (1) on the ignition lock assembly and separate the SKREEM from the ignition lock assembly.
NOTE: After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the
directions on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during this operation.
There is no need to program the fob of the key for RKE functionality once the transponder key is programmed to the new SKREEM/WCM.
NOTE: When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order:
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Program all ignition/transponder keys to the new SKREEM/WCM.
