Magnum V6-2.7L VIN T (2007)
12. Install stabilizer bar (4) with cushions and retainers on crossmember.
13. Install cushion retainer mounting bolts (1). Do not tighten at this time.
14. Install bolt (3) and nut fastening stabilizer bar ends to each stabilizer link (2). Do not tighten at this time.
15. Tighten cushion retainer mounting bolts (1) to 60 Nm (44 ft. lbs.).
CAUTION: Differential mounting bolts (1) must be installed through bushings prior to crossmember installation in vehicle. Bolts cannot be
inserted through bushings once crossmember is installed.
16. Transfer differential mounting bolts (1) from original crossmember differential mount bushings to bushings in replacement crossmember. Install
bolts from rear. Be sure to insert bolts through correct mount bushings in crossmember depending on rear axle differential (198 mm axle
differential shown in figure).
NOTE: Do not install coil springs on spring links at this time.
