Magnum V6-2.7L VIN T (2007)
1. Engage the lower edge of the upper D-pillar trim (2) under the upper edge of the quarter trim panel (4) at the inner D-pillar (3).
2. Align the two lower spring clip retainers on the back of the trim with the slots in the inside of the D-pillar.
3. Using hand pressure, press firmly and evenly on the trim over each of the lower spring clip locations until the retainers snap into place.
4. Align the two upper spring clip retainers on the back of the trim with the slots in the inside of the D-pillar and the upper liftgate opening header
(1).
5. Using hand pressure, press firmly and evenly on the trim over each of the spring clip locations until the retainers snap into place.
6. Reinstall the rear edge of the quarter trim panel to the inside of the lower D-pillar.
7. Reinstall the trim plate onto the upper liftgate opening header.
Quarter Trim Panel - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear seat cushion from the vehicle.
3. Remove the rear seat back side bolster from the quarter inner panel (1).
