Magnum V6-2.7L VIN T (2007)
5. Using hand pressure, press firmly and evenly on the trim over the spring clip location until the retainer snaps into place.
6. Move the rear of the quarter trim panel away from the base of the upper D-pillar trim far enough to access and reconnect the body wire harness
connector to the back of the auxiliary power outlet, if equipped.
7. Align the three spring clip retainers on the back of the quarter trim panel with the slots in the quarter inner panel behind the rear wheel house.
8. Using hand pressure, press firmly and evenly on the trim over the spring clip locations until the retainers snap into place.
9. Position the rear extension of the quarter trim panel onto the top of the liftgate opening lower panel with the extension sequenced under the end of
the liftgate scuff plate.
10. Install and tighten the three screws (4) that secure the tie-down loop (6) and the quarter trim panel to the quarter inner panel. Tighten the screws to
11 Nm (8 ft. lbs.).
11. Install and tighten the screw that secures the tie-down loop, the liftgate scuff plate and the rear extension of the quarter trim panel to the top of the
liftgate opening lower panel. Tighten the screw to 11 Nm (8 ft. lbs.).
12. Install and tighten the two screws (2) that secure the quarter trim panel to the speaker bracket above the rear wheel house. Tighten the screws to 11
Nm (8 ft. lbs.).
13. Reinstall the speaker bezel onto the quarter trim panel.
14. Reinstall the trim onto the upper D-pillar.
15. Install and tighten the screw that secures the outboard rear seat belt lower anchor to the quarter inner panel. Tighten the screw to 32 Nm (24 ft.
lbs.).
16. Reinstall the rear seat back side bolster onto the quarter inner panel.
17. Reinstall the rear seat cushion into the vehicle.
Quarter Trim Speaker Bezel - Removal
REMOVAL
1. Remove the screw in the cargo cover cradle formation of the quarter trim speaker bezel (2) that secures the bezel to the quarter trim panel (3) on
top of the rear wheel house.
2. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the front edge of the speaker bezel upward from the quarter trim panel far
enough to disengage the two spring clip retainers that secure the bezel to the slots in the trim panel.
3. Disengage the rear outboard seat belt webbing (1) from the quarter trim speaker bezel through the slit below the slot at the front of the bezel.
4. Lift the front of the quarter trim speaker bezel upward and pull it forward far enough to disengage the tabs at the back of the bezel from the slots in
the back of the quarter trim panel opening.
