Magnum V6-2.7L VIN T (2007)
4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
5. Remove banjo bolt (6) connecting flexible brake hose (1) to caliper (5). There are two sealing washers (7) (one one each side of hose fitting) that
will come off when bolt is removed. Discard these washers; install NEW washers on installation.
6. While holding guide pins from turning, remove caliper guide pin bolts (2).
7. Remove brake caliper (1) from brake adapter (3) and pads.
All-Wheel-Drive
ALL-WHEEL-DRIVE
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary.
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block over piston before installing C-clamp to avoid damaging piston.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
2. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
