Magnum V6-2.7L VIN T (2007)
CAUTION: Do not use a screw driver or other metal tool for seal removal. Using such tools can scratch bore or leave burrs on seal
groove edges.
7. Using a soft tool such as a plastic trim stick (2), work piston seal (1) out of its groove in caliper piston bore. Discard used seal.
8. Remove caliper bleeder screw (1) from caliper housing (2).
9. Clean piston bore and drilled passage ways with alcohol or a suitable solvent. Wipe it dry using only a lint-free cloth.
10. Inspect both piston and bore for scoring or pitting.
NOTE: It is not recommended to hone caliper bore. The anodized coating would be compromised.
Assembly
ASSEMBLY
CAUTION: Dirt, oil, and solvents can damage caliper seals. Ensure assembly area is clean and dry.
NOTE: Always use new, clean Mopar(R) DOT 3 Motor Vehicle Brake Fluid or equivalent when assembling brake caliper.
NOTE: Never use used or old piston seals or boots for reassembly.
