Magnum V6-2.7L VIN T (2007)
CAUTION: When installing dust boot in following step, use care not to over-install boot or damage will occur. The boot (3) will bottom in
the counterbore before the top of the boot reaches the surface of the caliper. The boot will bottom with approximately 2 mm (1/16 inch)
(2) of boot still showing above caliper housing.
5. Seat dust boot (3) in caliper counterbore using Installer, Special Tool 9314, with Handle, Special Tool C-4171. Install dust boot until it bottoms.
Do not over-seat dust boot or damage will occur.
6. Install bleeder screw in correct threaded hole. Caliper housing is not side-specific, so it is important to install bleeder screw in threaded hole that
will be uppermost once caliper is installed on vehicle. Tighten bleeder screw to 15 Nm (125 in. lbs.) torque.
7. Install caliper on vehicle.
