Magnum V6-2.7L VIN T (2007)
2. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing
grommets using a rocking motion while firmly pressing down on fluid reservoir. Once installed, make sure fluid reservoir is touching the top of
both sealing grommets (2) or reservoir is not properly installed.
3. Install fluid reservoir mounting screw (3). Tighten screw to 28 Nm (250 in. lbs.) torque.
4. Connect wiring harness connector (4) to brake fluid level sensor (2) mounted in brake fluid reservoir (1).
5. Fill master cylinder fluid reservoir (1) with clean, fresh Mopar(R) Brake Fluid or equivalent.
6. Install access panel in cowl area.
WARNING: Be certain a firm brake pedal is achieved prior to attempting vehicle operation. If a firm brake pedal cannot be achieved,
bleed entire brake hydraulic system and check for leaks.
7. Road test vehicle to ensure proper operation of brakes.
