Magnum V6-2.7L VIN T (2007)
Power Distribution Module: Service and Repair
Integrated Power Module
Removal
REMOVAL
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected.
1. Disconnect and isolate the battery negative cable (2).
2. Open the battery cable nut cover to expose nut.
3. Remove battery cable nut and battery cable from the Integrated Power Module (IPM).
4. Disengage the outboard retaining clip, and rotate the IPM to access wire harness connectors.
5. Disconnect wire harness connectors from IPM.
