Magnum V6-2.7L VIN T (2007)
Evaporative Emission Control Canister: Service and Repair
Removal
REMOVAL
1. Disconnect negative battery cable.
2. Raise vehicle and support.
3. Remove the right rear tire.
4. Remove the inner splash shield.
5. Disconnect the EVAP line.
6. Unlock and disconnect electrical connector.
7. Remove mounting nut.
8. Slide assembly forward off of rear mounting brackets.
9. Disconnect vapor lines from EVAP canister.
10. Squeeze connector and pull.
11. Make sure that you do not lose the rubber mounts in canister brackets.