Magnum V6-2.7L VIN T (2007)
l.
Verify the part number at the top of the "Flash PCM" screen has updated to the new part number.
7.
After flash reprogramming, be sure to Perform the additional Repair Steps associated with each procedure. These steps may include VLP clear
counters, Quick Learn and/or Re-enable TCC break in. It is important to perform these additional steps in the order listed for each repair.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored
DTCs" if there are any DTCs shown on the list.
NOTE:
The following step is required by law when reprogramming a PCM and/or TCM.
8.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
