Magnum V6-2.7L VIN T (2007)
1. Also refer to Modes of Operation.
The PCM operates the fuel system. The PCM is a pre-programmed, triple microprocessor digital computer. It regulates ignition timing, air-fuel ratio,
emission control devices, charging system, certain transmission features, speed control, air conditioning compressor clutch engagement and idle speed.
The PCM can adapt its programming to meet changing operating conditions.
The PCM receives input signals from various switches and sensors. Based on these inputs, the PCM regulates various engine and vehicle operations
through different system components. These components are referred to as Powertrain Control Module (PCM) Outputs. The sensors and switches that
provide inputs to the PCM are considered Powertrain Control Module (PCM) Inputs.
The PCM adjusts ignition timing based upon inputs it receives from sensors that react to: engine rpm, manifold absolute pressure, engine coolant
temperature, throttle position, transmission gear selection (automatic transmission), vehicle speed and the brake switch.
The PCM adjusts idle speed based on inputs it receives from sensors that react to: throttle position, vehicle speed, transmission gear selection, engine
coolant temperature and from inputs it receives from the air conditioning clutch switch and brake switch.
Based on inputs that it receives, the PCM adjusts ignition coil dwell. The PCM also adjusts the generator charge rate through control of the generator
field and provides speed control operation.
NOTE: PCM Inputs:
-
A/C request
-
Auto shutdown (ASD) sense
-
Battery temperature
-
Battery voltage
-
Brake switch
-
Camshaft position sensor signal
-
Crankshaft position sensor
-
Data link connections for scan tool
-
Engine coolant temperature sensor
-
Five volts (primary)
-
Five volts (secondary)
-
Fuel level
-
Generator (battery voltage) output
-
Ignition circuit sense (ignition switch in on/off/crank/run position)
-
Intake manifold air temperature sensor
-
Leak detection pump (switch) sense (if equipped)
-
Manifold absolute pressure (MAP) sensor
-
Oil pressure
-
Overdrive/override switch
-
Oxygen sensors
-
Park/neutral switch (auto. trans. only)
-
Power ground
-
Sensor return
-
Signal ground
-
Speed control multiplexed single wire input
-
Throttle position sensor
-
Transmission governor pressure sensor
-
Transmission temperature sensor
-
Vehicle speed (from ABS module)
NOTE: PCM Outputs:
-
A/C clutch relay
-
Auto shutdown (ASD) relay
-
circuits for: speedometer, voltmeter, fuel gauge, oil pressure gauge/lamp, engine temp. gauge and speed control warn. lamp
-
Data link connection for scan tool
-
EGR valve control solenoid (if equipped)
-
EVAP canister purge solenoid
-
Fuel injectors
-
Fuel pump relay
-
Generator field driver (-)
-
Generator field driver (+)
-
Generator lamp (if equipped)
-
Ignition coil
-
Natural Vacuum Leak detection Switch
-
Malfunction indicator lamp (Check engine lamp). Driven through Bus Messages.
