Magnum V6-2.7L VIN T (2007)
trim cover.
NOTE: Make sure that the horn switch wire harness is routed through the cut-out on the side of the trim cover and positioned in the hook on the
back of the housing. Attach connector to the housing.
2. Push down on the latch hook mounting plate and guide the latch hooks into the slots on the driver airbag cover.
3. Once all the latch hooks have been started, pull the driver airbag cover away from the driver airbag to fully seat the latch hooks.
4. Install the driver airbag (2). Torque the two screws (1) to 10 Nm (89 in. lbs.).
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test