Magnum V6-2.7L VIN T (2007)
torque.
d. Make sure brake hose is properly routed and will not come in contact with suspension components.
43. If equipped with SRT8 disc brakes, at each rear disc brake, support spring link using a transmission jack or other appropriate jack as indicated in
removal procedure.
44. If equipped with SRT8 disc brakes, on each rear disc brake, slide caliper with pads (2) over brake rotor and align with knuckle.
45. If equipped with SRT8 disc brakes, on each rear disc brake, install caliper mounting bolts (1). Tighten bolts to 130 Nm (96 ft. lbs.).
46. If equipped with SRT8 disc brakes, on each rear disc brake, remove jack from under spring link.
47. Route front parking brake cable with equalizer above rear crossmember.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
48. Connect left rear parking brake cable (1) to equalizer (2).
49. Connect right rear parking brake cable (4) to connector (3) already attached to front parking brake cable (5).
