Magnum V6-2.7L VIN T (2007)
4. Install halves of Support Clamp (1), Special Tool 9320-1, over ball joint (2) and around knuckle surface (3) as shown. Install and snug Support
Clamp (1) screws from underside.
5. Position knuckle (1) over tools guiding top of ball joint inside of Receiver (6), then hand tighten Press screw-drive (4) until Remover (3) comes
into contact with bottom of ball joint (2).
NOTE: When positioning knuckle over tools, make sure Receiver, Special Tool 9320-5, sets into recessed area (4) of Support Clamp,
Special Tool 9320-1.
6. Tighten Press screw-drive (4) forcing ball joint out of knuckle (1) and into Receiver (6).
7. Loosen screw-drive (4) and remove knuckle (1) from Press. Remove ball joint from Receiver (6).