Magnum V6-2.7L VIN T (2007)
12 Nm (106 in. lbs.).
3. Slide the gear shift lever boot down gear shift lever (1) and snap it into place on the cluster bezel (3).
4. Route the AutoStick wiring (3) along the right side of the column gear shift mechanism and install a wiring tie strap (2) securing the AutoStick
wiring to the column.
5. Connect the AutoStick wiring connector (1).
6. Check AutoStick wiring (3), making sure it is routed away from movable portions of shift mechanism.
7. Install the steering column opening reinforcement (1).
8. Install the steering column opening cover.
9. Install the negative battery terminal on the battery. It is important that this is performed properly (including calibration of steering angle sensor if
equipped with ESP).
