Magnum V6-3.5L VIN V (2006)
6. Install caliper bleeder screw (2) in caliper housing (1). Tighten bleeder screw to 15 Nm (125 inch lbs.) torque.
7. Install caliper on vehicle.
INSTALLATION
AWD
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary.
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block over piston before installing C-clamp to avoid damaging piston.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
2. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
3. Slide caliper (3) over brake pads and onto caliper adapter (2).
CAUTION: Extreme caution should be taken not to crossthread caliper guide pin bolts (1) when they are installed.
4. Align caliper mounting holes with guide pins, then install guide pin bolts (1). While holding guide pins from turning, tighten bolts to 60 Nm (44 ft.
lbs.) torque.
