Magnum V6-3.5L VIN V (2006)
4. Install piston (1) into caliper piston (2) bore, pressing piston down to bottom of bore using hand-pressure. Using a piece of wood or wooden
hammer handle may also suffice as long as piston and boot damage can be avoided.
CAUTION: When installing dust boot in following step, use care not to over-install boot or damage will occur. The boot (3) will bottom in the
counterbore before the top of the boot reaches the surface of the caliper. The boot will bottom with approximately 2 mm (1/16 inch) (2) of boot
still showing above caliper housing.
5. Seat dust boot (3) in caliper counterbore using Installer, Special Tool 9314, with Handle, Special Tool C-4171. Install dust boot until it bottoms.
Do not over-seat dust boot or damage will occur.
