Magnum V6-3.5L VIN V (2006)
CAUTION: When replacing master cylinder on vehicle, a NEW vacuum seal (2) MUST be installed on master cylinder.
2. Install NEW vacuum seal (2) on rear of master cylinder making sure seal fits squarely in mounting groove.
3. Position master cylinder (4) on studs of power brake booster, aligning booster push rod with master cylinder piston.
4. Install two master cylinder mounting nuts (1). Tighten both mounting nuts to 25 Nm (221 inch lbs.) torque.
CAUTION: When tightening primary and secondary brake tube nuts at master cylinder, be sure brake tubes do not contact any other components
within vehicle and that there is slack in flexible sections of tubes. This is required due to movement between ABS ICU and master cylinder while
vehicle is in motion.
5. Thread primary (3) and secondary (2) brake tubes into master cylinder primary and secondary ports. Tighten tube nuts to 20 Nm (177 inch lbs.)
torque.
NOTE: SRT8 vehicles are not equipped with a master cylinder mounted pressure switch for the Electronic Stability Program. The switch is
located in the primary brake tube.
