Magnum V6-3.5L VIN V (2006)
70.
Install the generator upper support bracket and tighten bolts to 48 ft. lbs. (65 N.m).
71.
Install the engine dipstick.
72.
Install six new quarts of 10W30 engine oil into the engine.
73.
Connect the battery.
74.
Verify the seating of the cargo floor panel.
75.
Start the vehicle and inspect for leaks.
76.
Return vehicle to the customer.
B. CS (FWD & AWD) Engine Inspection
1.
Open the hood.
2.
Disconnect the battery.
NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
3.
Remove engine trim cover.
4.
Remove engine oil dipstick.
5.
Remove dipstick tube mounting bolt and remove the dipstick tube from the engine oil pan.
6.
Remove serpentine belt.
7.
Raise the vehicle on a suitable hoist.
8.
Remove the right wheel well lower splash shield.
9.
Remove the four air conditioning compressor bolts. Set the compressor aside and secure.
10.
Remove the air conditioning compressor mounting bracket.
11.
Remove the power steering return hose bracket and set aside.
12.
AWD models: Remove the powertrain structural collar bracket between the engine oil pan and the transmission (Figure 21).
13.
Drain engine oil and remove the oil filter.
