Magnum V6-3.5L VIN V (2006)
195. Assemble the right axle to the right steering knuckle (Figure 46).
196. Assemble the right steering knuckle to the strut and install the pinch bolts.
Tighten the bolts to 65 ft. lbs. (88 N.m) + 90 (Figure 46).
197. Install the right axle hub nut. Tighten the nut to 180 ft. lbs. (244 N.m) and install retainer and cotter pin (Figure 46).
198. Install the right sway bar link to the right front strut and tighten the nut to 65 ft. lbs. (88 N.m) (Figure 46).
199. Install the right wheel speed sensor and retainer. Tighten the bolt to 96 in. lbs. (11 N.m).
200. Install the left fascia and tighten the screws.
201. Install the ground cable to the transaxle housing.
202. Assemble the left axle shaft into the left steering knuckle.
203. Assemble the left steering knuckle to the left strut. Install the pinch bolts and tighten the bolts to 65 ft. lbs. (88 N.m) + 90 (Figure 46).
204. Install the left axle hub nut. Tighten the nut to 180 ft. lbs. (244 N.m) and install retainer and cotter pin.
205. Install the left sway bar link to the left front strut. Tighten the nut to 65 ft. lbs. (88 N.m) (Figure 46).
206. Install the left wheel speed sensor and retainer. Tighten the bolt to 8 ft. lbs. (11 N.m).
207. Connect the engine wire harness to the PCM.
208. Install both the right and left inner fender liners.
209. Install the right and left wheel/tire assemblies and tighten the lug nuts to 110 ft. lbs. (149 N.m).
210. Lower the vehicle.
211. Connect the front oxygen sensor to the electrical wire harness.
212. Connect the engine harness to the chassis harness.
213. Attach the starter electrical harness to the starter.
214. Connect the duty cycle purge solenoid to the electrical harness.
215. Connect the generator to the electrical harness.
216. Connect the air conditioning clutch to the electrical harness.
