Magnum V6-3.5L VIN V (2006)
28.
Remove the upper radiator hose completely.
29.
Remove the serpentine belt.
30.
Remove the power steering pump and set it aside.
31.
Remove the lower coolant hose from the engine.
32.
Disconnect the high pressure line to the air conditioning compressor.
33.
Using clean caps, plug the end of the high pressure air conditioning line and the open port in the air conditioning compressor.
34.
Disconnect the low pressure line to the air condition compressor.
35.
Using clean caps, plug the end of the low pressure air conditioning line and the open port in the air conditioning compressor.
36.
Remove the coolant recovery bottle hose.
37.
Disconnect heater hose from the rear of the engine. the engine.
38.
Remove the engine wire harness / support bracket from the top of the transmission bell housing.
39.
Remove the ground strap from the right side transmission bell housing bolt (Figure 33).
40.
Remove the remaining upper four transmission bell housing bolts.
41.
Raise the vehicle.
42.
Remove the crank position sensor.
43.
Disconnect the electrical connections at the starter.
44.
Remove the starter, spacer, wire harness hanger and the dust shield.
45.
Remove the six bolts fastening the torque converter to the drive plate.
46.
Remove the right side dust shield where the transmission bell housing and engine join.
47.
Remove the air conditioning compressor and set aside away from the engine.
48.
Remove the remaining transmission bell housing to engine bolts.
49.
Remove the heat shield and the left exhaust pipe flange from the engine exhaust manifold.
50.
Remove the right side exhaust pipe from the engine exhaust manifold.
51.
Remove the coolant hose from the heater to the oil cooler and set aside.
52.
Remove the right and left engine mount bolts from the bottom of the suspension cradle.
53.
Lower the vehicle.
