Magnum V6-3.5L VIN V (2006)
45.
Remove left axle hub nut (Figure 40).
46.
Remove left steering knuckle to strut pinch bolts and separate (Figure 40).
47.
Pull left knuckle outboard to separate it from the axle shaft.
48.
Remove the ground cable from the transaxle housing.
49.
Remove the left fascia screws.
50.
Remove the right wheel speed sensor and retainer.
51.
Remove the right sway bar link at the right front strut.
52.
Remove the right axle hub nut.
53.
Remove the right steering knuckle to strut pinch bolts and separate.
54.
Separate the right axle from the right steering knuckle.
55.
Remove the torque converter to drive plate bolts.
56.
Separate the harness fastener of the mid-catalyst oxygen sensor from the cradle.
57.
Disconnect the mid-catalyst oxygen sensor connector.
58.
Remove the two exhaust pipe flange-to-exhaust manifold nuts.
59.
Pry the heat shield tab off the exhaust manifold stud.
60.
Separate the exhaust pipe from the engine and support the exhaust system.
61.
Remove the vehicle center exhaust system hanger bolts.
62.
Remove the vehicle rear exhaust system hanger bolts.
63.
Remove the exhaust system from the vehicle.
64.
Separate the brake lines from the brake line spacer isolator located on the left side of the engine compartment by the brake hydraulic control unit.
65.
For AWD model:
a.
Paint mark the propeller shaft to the rear differential at the PTU.
b.
Separate the propeller shaft to the rear differential at the transaxle power transfer unit. Support the propeller shaft to the under body.
