Magnum V6-3.5L VIN V (2006)
c.
Remove engine/transaxle assembly support plate from the suspension cradle.
66.
Remove steering coupling pin using tool # 6831A.
67.
Remove both engine mount-to-suspension cradle nuts.
68.
Paint mark the suspension cradle to the chassis.
69.
Disconnect the crank position sensor.
70.
Position the front (right and left) brake lines aside to clear the suspension cradle when it is dropped.
71.
Place suspension cradle support fixture (essential tool # 8874) under the vehicle.
72.
Lower the vehicle onto the suspension cradle support fixture.
73.
Remove right engine support mount.
74.
Remove all four suspension cradle-to-body bolts.
75.
Raise the vehicle and slide the suspension cradle fixture out from under the vehicle.
NOTE:
The following steps will be performed with the engine and transaxle on the suspension cradle.
76.
Remove the left axle shaft.
77.
Remove the serpentine drive belt.
78.
Remove the generator.
79.
Remove the power steering reservoir.
80.
Remove the power steering pump.
81.
Remove the belt tensioner.
82.
Remove the three idler pulleys.
83.
Disconnect the IAC connector at the throttle body.
84.
Disconnect the TPS connector at the throttle body.
85.
Disconnect the intake manifold short runner actuation valve connector.
86.
Disconnect the intake manifold long runner actuation valve connector.
87.
Disconnect the MAP sensor located on the intake manifold.
88.
Unfasten the wiring harness support bracket.
89.
Remove the PVC hose.
90.
Remove the PVC valve.
91.
Remove crankshaft damper.
92.
Remove EGR tube.
93.
Remove oil fill tube.
94.
Remove the two intake manifold support brackets.
95.
Remove the intake manifold from the engine.
