Magnum V6-3.5L VIN V (2006)
96.
Disconnect the remaining components from the engine wire harness (knock sensor, fuel injectors, ignition coils, ignition noise suppression
capacitors, EGR valve, cam position sensor, oil pressure sending unit, etc).
97.
Remove the engine wire harness.
98.
Remove right rear exhaust heat shield.
99.
Remove exhaust cross over pipe.
100. Remove the front exhaust manifold and discard the exhaust manifold to engine gasket.
101. Remove the rear exhaust manifold and discard the exhaust manifold to engine gasket.
102. Remove the EGR valve and discard the EGR valve-to-cylinder head gasket.
103. Remove the ignition coil packs.
104. Remove the coolant hoses from the engine (oil cooler-to-engine, oil cooler-to-heater).
105. Remove the valve cover ground straps.
106. Remove the transaxle rear structural support bolt from the engine.
107. Remove the starter from the engine.
108. Remove the crankshaft position sensor.
109. Remove the air conditioning compressor.
110. Remove the air conditioning compressor mounting bracket.
111. For AWD models: Remove the PTU (Figure 41).
a.
Remove the PTU/transaxle left upper bracket.
b.
Remove the PTU heat shield.
c.
Remove the PTU collar bolts from the oil pan.
d.
Remove the PTU to transaxle bolts.
e.
Separate the PTU from the transaxle.
