Magnum V6-3.5L VIN V (2006)
14.
Install the engine oil drain plug into the engine oil pan and tighten.
15.
Remove the access cover for the transmission torque converter drive plate bolts (Figure 22).
16.
Remove the oil pan bolts and nuts.
17.
Using a putty knife, separate the oil pan from the oil pan gasket. Carefully remove the oil pan. The oil pan gasket should remain attached to the
block.
NOTE:
If the oil pan gasket is attached to the block at all four corners, be careful not to dislodge the gasket while completing this section.