Magnum V6-3.5L VIN V (2006)
22.
Disconnect the transaxle solenoid packs.
23.
Remove the transaxle electrical harness from the transaxle by prying loose the wire harness from the clip.
24.
Discharge the air conditioning system using a suitable refrigerant recovery system.
25.
Remove the engine wire harness ground at left inner frame rail.
26.
Disconnect the transaxle selector shift cable.
27.
Disconnect the transaxle oil cooler lines at the radiator.
28.
Disconnect the block heater (if so equipped) 110 v power cord at the heater.
29.
Disconnect the hose to the coolant recovery bottle.
30.
Disconnect all heater hoses at the heater.
31.
Disconnect the front brake lines. Use a brake pedal prop to prevent draining of the brake fluid from the brake reservoir.
32.
Disconnect both air conditioning lines at the compressor and cap off the openings.
33.
Disconnect the air conditioning clutch electrical connector.
34.
Disconnect the electrical harness from the generator.
35.
Disconnect the electrical harness from the duty cycle purge solenoid.
36.
Disconnect the electrical harness from the starter.
37.
Disconnect the engine harness from the chassis harness.
38.
Disconnect the front oxygen sensor.
39.
Raise the vehicle.
40.
Remove both front wheel/tire assemblies.
41.
Unfasten the front half of both right and left inner fender liners and roll the liners rearward.
42.
Disconnect the harness from the PCM.
43.
Disconnect the left wheel speed sensor connector and the speed sensor wire from the retainer.
44.
Disconnect the left sway bar link at the left front strut (Figure 40).
