Magnum V6-3.5L VIN V (2006)
112. Remove all engine-to-transaxle bell housing bolts.
113. Connect one end of the engine lifting bracket from special tool kit 8534 to the right rear of the cylinder head outer most bolt access hole with a
bolt and tighten (Figure 42).
114. Install a bolt into the inner most bolt access hole next to the engine lift bracket to position the engine lift bracket (Figure 42).
115. Connect an engine hoisting chain to the left timing chain cover engine lift eye and to the engine lift bracket installed in Step 113 (Figure 43).
116. Lift the engine with a suitable hoist such that the front and rear engine mounts just lift off the suspension cradle.
117. Remove front engine mount.
118. Remove rear engine mount.
119. Carefully separate the engine from the transaxle.
120. Place the old engine in a suitable cradle to prevent the engine from tipping on its side.
121. Remove the drive plate and discard the bolts.
122. Remove the engine lifting chain and bracket.
123. Install the engine lifting chain and bracket onto the new engine by repeating Step 113 through Step 115.
124. Spread a light coating of universal suspension grease all around in the hole at the end of the crankshaft where the nose of the torque converter
nests.
125. Install the drive plate with new bolts and tighten to 55 ft. lbs. (75 N.m).
126. Position and align the engine to the transaxle. Make sure the engine dowels are properly seated into the transaxle.
127. Install the upper four engine to transaxle bell housing bolts and tighten to 70 ft. lbs. (95 N.m).
128. Install the rear engine mount plate and tighten bolts to 40 ft. lbs. (54 N.m).
129. Install the rear engine mount upper nut and tighten to 75 ft. lbs. (101 N.m).
130. Install the rear engine mount bracket bolts and tighten to 40 ft. lbs. (54 N.m).
131. Install the rear engine mount to the engine mount bracket and tighten to 75 ft. lbs. (101 N.m).
132. Install the left motor mount to the engine block and tighten the bolts to 40 ft. lbs. (54 N.m).
