Magnum V6-3.5L VIN V (2006)
n.
Install left and right sway bar link bolts to the strut clevis brackets and tighten bolt to 95 ft. lbs. (128 N.m) (Figure 19).
o.
Install right and left hub nuts to right and left axles and tighten to 157 ft. lbs. (213 N.m).
p.
Install right and left brake pads and calipers. Tighten caliper bolts to 44 ft. lbs. (60 N.m).
q.
Install right and left upper control arm ball joint to steering knuckle. Tighten the bolt to 35 ft. lbs. (47 N.m) + 90° (Figure 19).
r.
Install right and left vehicle speed sensors to the steering knuckle. Tighten bolts to 96 in. lbs. (11 N.m) (Figure 20).
s.
Install right and left front wheel and tire assembly and tighten the lug nuts to 110 ft. lbs. (149 N.m).
t.
Check the front differential for proper differential oil level. Adjust as needed.
64.
For RWD models:
a.
Install the steering rack to the sub-frame and tighten the bolts to 75 ft. lbs. (102 N.m).
b.
Align the steering coupler to the steering gear using the mark made in Step 16 (a).
c.
Install the steering coupler bolt and tighten to 40 ft. lbs. (54 N.m).
65.
Install the lower plastic splash shield underneath the engine.
66.
Lower the vehicle to the ground.
67.
Inspect the dipstick tube "O" ring for damage. Replace the "O" if necessary (PN 05003905AA).
68.
Install the dipstick tube into the oil pan.
69.
Install the dipstick tube mounting bolt and tighten to 30 ft. lbs. (41 N.m).
