Magnum V6-3.5L VIN V (2006)
16.
For RWD model:
a.
Mark the steering column coupler in relation to the steering gear.
b.
Remove the steering column bolt at the coupler and separate the steering column coupler from the steering gear (Figure 5).
c.
Remove the two bolts holding the steering rack to the sub frame and allow the steering rack to hang freely.
17.
Remove the drive plate access cover to gain access to the rear two engine oil pan bolts (Figure 6).
18.
Remove the two rear engine oil pan retaining bolts.
19.
Remove the four rear engine oil pan to transmission bell housing bolts.
20.
Remove the metal dust shield at the right rear side of oil pan.
21.
Remove the remaining oil pan bolts and nuts.
22.
Using a putty knife, separate the oil pan from the oil pan gasket. Carefully remove the oil pan. The oil pan gasket should remain attached to the
block.
NOTE:
If the oil pan gasket is attached to the block at all four corners, be careful not to dislodge the gasket while completing this section.