Magnum V6-3.5L VIN V (2006)
50.
Install one engine oil pan to transmission bell housing 10 mm bolt at the right lower hole (Figure 16).
51.
Install one engine oil pan to transmission bell housing 10 mm bolt at the left lower hole (Figure 16).
52.
Pre-tighten the two engine oil pan to transmission bell housing 10 mm bolts installed in Step 50 and 51 to 12 in. lbs. (1.4 N.m ).
53.
Hand-start each of the remaining engine oil pan bolts and nuts.
54.
Tighten the oil pan bolts as follows:
a.
Tighten the right rear engine oil pan bolt first to 20 ft. lbs. (28 N.m) (Figure 15).
b.
Tighten the left rear engine oil pan bolt to 20 ft. lbs. (28 N.m) (Figure. 15).
c.
Tighten the two 6 mm engine oil pan bolt located in the access opening to 105 in. lbs (12 N.m) (Figure 15).
55.
Tighten the remaining 8 mm oil pan bolts and nuts to 20 ft. lbs. (28 N.m).
56.
Position the metal dust shield at the right rear side of oil pan and hand-start the two remaining engine oil pan to transmission bell housing bolts.
57.
Tighten the four 10 mm engine oil pan to transmission bell housing bolts to 40 ft. lbs. (55 N.m).
58.
Install the torque converter access cover (Figure 16) and tighten the fastener to 97 in. lbs. (11 N.m).
59.
Wipe clean both the upper engine oil cooler sealing "O" ring and the oil filter sealing surface.
60.
Position oil cooler to fitting on oil pan. The notch in the engine oil pan oil cooler pad must fit into the cut-out of the oil cooler.
61.
While holding the engine oil cooler in position, install the oil cooler/filter nipple and tighten to 45 ft. lbs. (61 N.m).
NOTE:
Do not over tighten. Damage to the oil cooler will occur.
62.
Install a new oil filter and tighten to 106 in. lbs. (12 N.m).
63.
For AWD models:
a.
Lower the vehicle part way to perform suspension operations.
