Magnum V6-3.5L VIN V (2006)
133. Lower the engine into the suspension cradle and remove the engine lifting chain and bracket.
134. Install the remaining engine-to-transaxle bell housing bolts and tighten to 70 ft. lbs. (95 N.m).
135. For AWD models: Install PTU unit (Figure 41) as follows:
a.
Align the PTU into the transaxle, install the upper bolts and tighten to 40 ft. lbs. (54 N.m).
b.
Install the PTU to transaxle lower bolts and tighten to 21 ft. lbs. (28 N.m).
c.
Install the PTU collar and brace bolts to the oil pan and tighten to 40 ft. lbs. (54 N.m).
d.
Install the PTU heat shield and tighten bolts to 20 ft. lbs. (28 N.m).
e.
Install the PTU/transaxle left bracket and tighten the bolts to 40 ft. lbs. (54 N.m).
136. Install the air conditioning mounting bracket and hand start the four bolts. Then tighten the bolts to 30 ft. lbs. (41 N.m) in the sequence as follows
(Figure 44):
a.
Tighten the upper rear bolt.
b.
Tighten the upper front bolt.
c.
Tighten the bottom rear bolt.
d.
Tighten the bottom front bolt.
137. Install the air conditioning compressor. Snug the bolts at this time.
138. Install the crankshaft position sensor.
139. Install the starter, dust shield, spacer, and bracket. Tighten the bolts to 40 ft. lbs. (54 N.m).
140. Install the transaxle rear structural support bolt to the engine and tighten to 40 ft. lbs. (54 N.m).
141. Install the ground straps onto the front cylinder head cover and to the cylinder head.
142. Install the coolant hoses to the engine (oil cooler-to-engine and oil cooler-to-heater).
143. Install the ignition coil packs.
144. Remove the plug in the EGR passage at the rear of the right cylinder head (rear cylinder head).
