Magnum V6-3.5L VIN V (2006)
1. Position the front floor distribution duct (2) to the bottom of the HVAC air distribution housing (3).
2. Install the six screws (1) that secure the front floor distribution duct to the air distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
3. Install the air distribution housing
Intermediate Floor Distribution Ducts
DUCT-FLOOR DISTRIBUTION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY OR DEATH.
NOTE:
-
Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
-
LHD model shown. RHD model similar.
INTERMEDIATE FLOOR DISTRIBUTION DUCTS
REMOVAL
1. Remove the center floor console.
2. Remove the front seats.
3. Roll back the front floor carpet from under the instrument panel toward the rear of the vehicle.
4. Remove the push pin fastener (1) that secures the passenger side front intermediate floor distribution duct (2) to the floor support (4).
5. Disconnect the passenger side front intermediate floor distribution duct from the front floor distribution duct (8).
