Magnum V6-3.5L VIN V (2006)
Fluid/filter Service Points
1. Run the engine until the transmission oil reaches operating temperature.
2. Raise and support vehicle.
3. Remove the bolts (5) and retainers (4) holding the oil pan to the transmission.
4. Remove the transmission oil pan (3) and gasket (2) from the transmission.
5. Remove the transmission oil filter (1) and O-ring from the electrohydraulic control unit.
6. Clean the inside of the oil pan (3) of any debris. Inspect the oil pan gasket (2) and replace if necessary.
7. Install a new oil filter (1) and O-ring into the electrohydraulic control unit.
8. Install the oil pan (3) and gasket (2) onto the transmission.
9. Install the oil pan bolts (5) and retainers (4). Torque the bolts to 8 Nm (70 inch lbs.).
10. Lower the vehicle and add 5.0 L (10.6 pts.) of transmission fluid to the transmission.
11. Check the oil level.
Fluid Fill
TRANSMISSION FILL
To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:
1. Verify that the vehicle is parked on a level surface.
2. Remove the dipstick tube cap.
3. Add following initial quantity of Mopar ATF +4, Automatic Transmission Fluid, to the transmission:
a. If only fluid and filter were changed, add 5.0 L (10.6 pts.) of transmission fluid to transmission.
b. If the transmission was completely overhauled or the torque converter was replaced or drained, add 7.7 L (16.3 pts.) of transmission fluid to
transmission.
4. Check the transmission fluid and adjust as required.
