Magnum V6-3.5L VIN V (2006)
9. Remove tube bolts (1) to EGR valve (2).
10. Remove tube (1) from intake manifold.
NOTE:Replace the EGR tube gasket and silicone rubber seals any time the EGR tube is removed from the intake manifold.
11. When removing EGR upper tube assembly being careful not to drop the silicone rubber seals in the intake manifold. Clean gasket surfaces on the
EGR valve. Note that any loose dirt can lodge between the pintle and the seat and cause valve leakage that will give a rough idle and depressed
manifold vacuum.
12. Clean mounting surface.
INSTALLATION
1. Clean mounting surface.
2. Install new rubber silicone seals on intake manifold end of EGR tube.
3. Lubricate the EGR mounting tube hole in the intake manifold with clean soapy water. Do not lubricate the EGR tube or seal.
4. Install tube into the intake manifold being careful that the silicone rubber seals are correctly installed and undamaged.
