Magnum V6-3.5L VIN V (2006)
Spark Plug Tube: Service and Repair
TUBE-SPARK PLUG
REMOVAL
1. Remove cylinder head cover(s).
2. Using suitable locking pliers, remove the tube from the cylinder head and discard tube.
3. Clean area around spark plug with Mopar Parts Cleaner or equivalent.
INSTALLATION
1. Apply Mopar Stud and Bearing Mount to a new tube (1) approximately 1 mm (0.039 inch) from the end of tube, in a 3 mm (0.118 inch) wide
area.
2. Install sealer end of tube (1) into the cylinder head. Then carefully install the tube (1) using a hardwood block and mallet. Install the tube (1) until
it is seated into the bottom of the bore.
3. Replace spark plug tube (1) seal if needed.
4. Install cylinder head cover(s).
