Magnum V6-3.5L VIN V (2006)
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer making
sure it is not worn or damaged. Washer can be installed in either direction on shaft.
18. Install hub and bearing as well as all components necessary to access it.
19. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
20. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (97 inch lbs.) torque.
21. Install sensor cable at rear brake rotor shield (1).
22. Lower vehicle.
23. Adjust parking brake shoes as necessary.
24. Position vehicle on alignment rack/drive-on hoist. Raise vehicle as necessary to access mounting bolts.
