Magnum V6-3.5L VIN V (2006)
7. Push in on cooler mounting clip tabs.
8. Remove cooler from clips mounted to cooling module.
INSTALLATION
FLUID COOLER
1. Install cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.
NOTE: If a lengthwise paint stripe appears on the return hose (3) near the end, position that paint stripe at the top (12 O'clock position) when
installed on the cooler. This positioning must be done to ensure proper hose routing.
2. Slide return hose to reservoir (3) onto left end of cooler (2). Install clamp securing hose in place.
