Magnum V6-3.5L VIN V (2006)
Clamp (1) screws from underside.
5. Position knuckle (1) over tools guiding top of ball joint inside of Receiver (6), then hand tighten Press screw-drive (4) until Remover (3) comes
into contact with bottom of ball joint (2).
NOTE: When positioning knuckle over tools, make sure Receiver, Special Tool 9320-5, sets into recessed area (4) of Support Clamp, Special
Tool 9320-1.
6. Tighten Press screw-drive (4) forcing ball joint out of knuckle (1) and into Receiver (6).
7. Loosen screw-drive (4) and remove knuckle (1) from Press. Remove ball joint from Receiver (6).