Magnum V6-3.5L VIN V (2006)
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
36. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4).
37. Insert front parking brake cable routing bracket locating pin into front flange of crossmember (3), then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
38. On each side of vehicle, slide an axle half shaft (2) through hub and bearing and install hub nut (1). Do not tighten hub nuts at this time.
