Magnum V6-3.5L VIN V (2006)
11. Remove shock absorber (3) by tipping top outward and lifting lower end out of pocket in spring link (4).
12. Disconnect brake hose at bracket mounted to body to allow to avoid overextending hose, damaging it, during following step.
13. Slowly lower jack until crossmember is low enough to remove coil spring. Do not lower jack any further than necessary to remove spring.
14. Remove coil spring and isolators (1, 2 and 5).
INSTALLATION
NOTE: Rear coil springs are interchangeable.
1. Install upper (1) and lower (5) isolators on coil spring (2).
NOTE: Before installing coil spring, make sure isolators (1 and 5) are completely installed on ends of spring.
